Subaru Legacy 2005 Service Manual page 2950

DIFFERENTIALS
3) Install the ST to rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
ST
4) Insert the spline shaft until the spline portion
comes inside the side oil seal.
ST 28099PA090 OIL SEAL PROTECTOR
ST
5) Remove ST from rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
6) Push the rear differential to insert the axle shaft
into rear differential.
7) Adjust the transmission jack, if necessary, and
insert the rear differential stud bolt into rear cross-
member bushing properly.
Rear Differential (VA-type)
8) After inserting the rear differential stud bolt into
rear crossmember bushing, lift up the transmission
jack and align the rear differential to the height of
rear differential.
DI-00300
9) Tighten a new self-locking nut temporarily to rear
crossmember.
DI-00289
10) Remove the band from rear differential. Lift up
the rear differential until the rear differential is left
from the transmission jack.
11) Install the rear differential front member with a
new self-locking nut.
Tightening torque:
DI-00281
DI-00393
DI-48
⋅
T1: 52 N m (5.3 kgf-m, 38 ft-lb)
⋅
T2: 110 N m (11.2 kgf-m, 81 ft-lb)
T2
T1
DI-00283
DI-00269
DI-00284