Ip Prefix List Commands; Clear Ip Prefix-List - Dell S4810 Reference Manual

Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version
6.1.1.0
Usage
When you use the log option, the CP processor logs details about the packets that
Information
match. Depending on how many packets match the log entry and at what rate, the
CP may become busy as it has to log these packets' details.
Related
deny
Commands
seq

IP Prefix List Commands

When you create an access-list without any rule and then apply it to an interface, the ACL behavior
reflects implicit permit.
To configure or enable IP prefix lists, use these commands.

clear ip prefix-list

Reset the number of times traffic mets the conditions ("hit" counters) of the configured prefix lists.
S4810
Syntax
clear ip prefix-list [prefix-name]
Parameters
prefix-name
Defaults Clears "hit" counters for all prefix lists unless a prefix list is specified.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL)
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the monitor option.
Introduced on the E-Series.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
— configures a MAC ACL filter to drop packets.
— configure a MAC ACL filter with a specified sequence number.
(OPTIONAL) Enter the name of the configured prefix list to
clear only counters for that prefix list, up to 140 characters
long.
263