Table of Contents
Advertisement
Conventional Brake Components
Brake Booster Replacement
1. Remove the master cylinder (see page 19-14).
2. Disconnect the vacuum hose (A) from the brake
booster (B), then remove the vacuum hose bracket
A
3. For M/T model only, remove the clutch reservoir
(D) and reservoir bracket. Do not disconnect the
clutch hose from the reservoir.
4. Remove the IAT sensor.
18 N m ( 1 . 8 k g f m , 1 3 I b f f t )
5. Remove the cotter pin (A) and joint pin (B).
B
C
8 x 1.25 m m
13 N m (1.3 k g f m , 9 . 4 I b f f t )
6. Remove the four booster mounting nuts (C).
7. Pull the brake booster (A) forward, then turn it to
the right until the clevis (B) is clear of the bulkhead
(C).
A
8. Remove the brake booster from the engine
compartment.
9. Install the brake booster in the reverse order of
removal, and note these items:
• Adjust the pushrod length before installing the
brake booster.
• After installation, adjust brake pedal height and
brake pedal free play (see page 19-5).
• Replace the IAT sensor O-ring and the booster
clevis cotter pin.
19-18
Advertisement
Table of Contents
Troubleshooting
