Drive Mode Selector Cable Adjustment - Honda MUV700 big red Service Manual

FRONT DRIVING MECHANISM
Install the lever grip with the tab facing forward.
Check the selector lever for smooth operation
Perform the cable adjustment if necessary (page 19-
44).
Install the battery box cover (page 21-6).
DRIVE MODE SELECTOR CABLE
ADJUSTMENT
Remove the following:
right front wheel (page 15-6)
- regulator/rectifier (page 21-8)
- battery box cover (page 21-6)
Set the drive mode selector lever to the 2WD posi-
tion.
Remove the bolt and the clutch arm cover by releas-
ing it from the two tabs.
Loosen the adjusting nut on the 2WD/4WD selector
,---~~~~--:-~~~~~~~~~~-,
19-44
cable thoroughly until the cable is not forced (to get
the clearance between the joint pin and upper side
of the arm slot).
JOINT PIN
SELECTOR
CABLE
~~
"f:
SLOT
'"
V""' __
ADJUSTING
NUT