Single-Shot Conversion Mode - Fujitsu F2MCTM-16LX Hardware Manual

CHAPTER 18 8-/10-BIT A/D CONVERTER
18.5.1

Single-shot Conversion Mode

In the single-shot conversion mode, A/D conversion is performed sequentially from the
start channel to the end channel. The A/D conversion stops at the termination of A/D
conversion for the end channel.
Setting of Single-shot Conversion Mode
Operating the 8-/10-bit A/D converter in the single-shot conversion mode requires the setting shown in
Figure 18.5-1 .
ADCS
ADCR
ADSR
ADER5
ADER6
−
: Undefined
: Used bit
: Set the bit corresponding to pin to be used as analog input pin to 1.
0 : Setting 0
360
Figure 18.5-1 Setting of Single-shot Conversion Mode
bit15 14 13 12 11 10
BUSY INT INTE PAUS STS1 STS0
− − − − −
ST2 ST1 ST0 CT2 CT1 CT0
ADE15ADE14ADE13ADE12ADE11ADE10 ADE9 ADE8
9 bit8 bit7 6 5
−
STRT MD1 MD0 S10
0
−
D9 to D0 (Converted data stored)
Re-
ANS3 ANS2 ANS1 ANS0
served served
0
ADE7 ADE6 ADE5 ADE4 ADE3 ADE2 ADE1 ADE0
4 3 2 1 bit0
Re-
− − − −
served
0
Re-
ANE3 ANE2 ANE1 ANE0
0