Starting Debugging; Enter Debugging Mode - Fujitsu F2MC-16FX MB2198 Getting Started

3 Starting Debugging

EXECUTING THE PROGRAM

3.1 Enter Debugging Mode

After a successful project built you can enter the debugger mode via three different
interfaces depending on your hardware set up:
•
PC-COM-Port (RS232)
•
LAN Interface
•
USB Port
By double clicking on the correct connection type of the Debug dependency in the Project
window (*.sup-files), your PC will connect to the MB2198 Emulator and the Softune
Workbench will enter the Debugging Mode. Please refer to the Installation Guide Application
Note (MCU-AN-390209-E) for detailed information.
After a successful connection the Softune Workbench will look like this:
Note, that the interface has to be determined only once. Later you can choose the menu
Debug > Start debug to enter this mode.
© Fujitsu Microelectronics Europe GmbH
MB2198 – Getting Started
Chapter 3 Starting Debugging
- 17 - MCU-AN-300217-E-V10