Reset Operation; Overview Of Reset Operation - Fujitsu F2MCTM-16LX Hardware Manual

CHAPTER 7 RESETS
7.4

Reset Operation

When the reset signal is inactivated, the reset vector and mode data is fetched from the
predetermined locations depending on the setting of the mode pins. This operation, the
mode fetch, then defines the operation mode of the CPU and the start address of the
first instruction. For the power on reset, reset from the stop mode or sub-clock mode,
the mode fetch is performed after the oscillation stabilization wait time is elapsed.

Overview of Reset Operation

Figure 7.4-1 shows the reset operation flow.
During reset
Mode fetch
(reset operation)
Normal operation
(RUN status)
*1: Product with T-suffix
*2: For MB90F367/T(S), MB90367/T(S)
Mode Pins
Setting the mode pins (MD0 to MD2) specifies how to fetch the reset vector and the mode data. Fetching
the reset vector and the mode data is performed in the reset sequence. See "9.1.1 Mode Pins", for details on
mode pins.
126
Figure 7.4-1 Reset Operation Flow
Power-on reset
Stop mode
Sub-clock mode
Oscillation stabilization wait
reset status
Fetch reset vector
Fetch mode data
Fetch the instruction code from
the address indicated by the reset
vector and execute instruction
External reset
Software reset
Watchdog timer reset
Low voltage detection reset*
CPU operation detection reset*
2
Clock supervisor reset*
1
1