Unblocking A User; Resetting The Pro3X; Restarting The Pro3X - LEGRAND Server Technology PRO3X User Manual

Variables:
• •
<n> is an actuator's ID number.
The ID number is available in the PRO3X web interface or using the show command in the
CLI. It is an integer starting at 1.
If you entered the command without "/y", a message appears, prompting you to confirm the operation.
Then:
• •
Type y to confirm the operation, OR
• •
Type n to abort the operation
Example - Turning On a Specific Actuator
The following command turns on the actuator whose ID number is 8.
# control actuator 8 on

Unblocking a User

If any user is blocked from accessing, you can unblock them at the local console.
▶
To unblock a user:
1) Access the CLI interface using any terminal program via a local connection.
2) When the Username prompt appears, type unblock and press Enter.
3) When the "Username to unblock" prompt appears, type the name of the blocked user and press
Enter.
4) A message appears, indicating that the specified user was unblocked successfully.

Resetting the PRO3X

You can reset the PRO3X to factory defaults or simply restart it using the CLI commands.

Restarting the PRO3X

This command restarts the PRO3X. It is not a factory default reset.
469