LEGRAND Server Technology PRO3X User Manual page 330

▶
Example 1 - Combination of ETH1's Activation, Configuration Method and IP
The following multi-command syntax configures IPv4 address, configuration method and activation
status for ETH1's network connectivity simultaneously.
config:# network ipv4 interface eth1 enabled true configMethod static
address 192.168.84.225/24
Results:
• •
The ETH1 interface is enabled.
• •
ETH1's configuration method is set to static IP address.
• • ETH1's IPv4 address is set to 192.168.84.225/24.
▶
Example 2 - Combination of Upper Critical and Upper Warning Settings
The following multi-command syntax simultaneously configures Upper Critical and Upper Warning
thresholds for the RMS current of the 2nd overcurrent protector.
config:# sensor ocp 2 current upperCritical disable upperWarning 15
Results:
• • The Upper Critical threshold of the 2nd overcurrent protector's RMS current is disabled.
• •
The Upper Warning threshold of the 2nd overcurrent protector's RMS current is set to 15A and
enabled at the same time.
▶
Example 3 - Combination of SSID and PSK Parameters
This multi-command syntax configures both SSID and PSK parameters simultaneously for the wireless
feature.
config:# network wireless SSID myssid PSK encryp_key
Results:
• •
The SSID value is set to myssid.
• •
The PSK value is set to encryp_key.
▶
Example 4 - Combination of Upper Critical, Upper Warning and Lower Warning Settings
The following multi-command syntax configures Upper Critical, Upper Warning and Lower Warning
thresholds for the outlet 5 RMS current simultaneously.
330