LEGRAND Server Technology PRO3X User Manual page 376

Setting Wireless Parameters
You must configure wireless parameters, including Service Set Identifier (SSID), authentication method,
Pre-Shared Key (PSK), and Basic Service Set Identifier (BSSID) after the wireless networking mode is
enabled.
A wireless configuration command begins with network wireless.
Note: If wireless networking mode is not enabled, the SSID, PSK and BSSID values are not applied until
the wireless networking mode is enabled. In addition, a message appears, indicating that the active
network interface is not wireless.
Setting the SSID
This command specifies the SSID string.
config:#
Variables:
• •
<ssid> is the name of the wireless access point, which consists of:
- Up to 32 ASCII characters
- No spaces
- ASCII codes 0x20 ~ 0x7E
Enabling or Disabling 802.11n High Throughput
This command enables or disables the 802.11n high throughput protocol.
config:# network wireless enableHT <option>
Variables:
• •
<option> is one of the options: true or false.
Option
true
false
Setting the Wireless Authentication Method
This command sets the wireless authentication method to None, PSK, or Extensible Authentication
Protocol (EAP).
config:# network wireless authMethod <method>
376
network wireless SSID <ssid>
Description
802.11n is enabled.
802.11n is disabled.