Actuator Control Operations - LEGRAND Server Technology PRO3X User Manual

# power outlets 2,6-8,10,13-16 cycle

Actuator Control Operations

An actuator, which is connected to a dry contact signal channel of a sensor package, can control a
mechanism or system. You can switch on or off that mechanism or system through the actuator control
command in the CLI.
Perform these commands in the administrator or user mode.
Switching On an Actuator
This command syntax turns on one actuator.
# control actuator <n> on
To quicken the operation, you can add the parameter "/y" to the end of the command, which confirms
the operation.
#
control actuator <n> on /y
Variables:
• • <n> is an actuator's ID number.
The ID number is available in the PRO3X web interface or using the show command in the
CLI. It is an integer starting at 1.
If you entered the command without "/y", a message appears, prompting you to confirm the operation.
Then:
• •
Type y to confirm the operation, OR
• •
Type n to abort the operation
Switching Off an Actuator
This command syntax turns off one actuator.
# control actuator <n> off
To quicken the operation, you can add the parameter "/y" to the end of the command, which confirms
the operation.
# control actuator <n> off /y
468