Before You Begin; Unpacking The Product And Components; Preparing The Installation Site - LEGRAND Server Technology PRO3X User Manual

Factory default is to enable IPv4 only. The link‑local IPv4 address is
ranges between 169.254.1.0 and 169.254.254.255.
• •
IPv6 address:
A link-local IPv6 address is available only after IPv6 is enabled on the PRO3X. See
Configuring Network Settings.
• • Host name - pdu.local:
You can type
address.
▶
Retrieval of the link-local address:
• •
See Device Info.

Before You Begin

Before beginning the installation, perform the following activities:
• • Unpack the product and components
• •
Prepare the installation site
• •
Check the branch circuit rating
• •
Fill out the equipment setup worksheet

Unpacking the Product and Components

1) Remove the product and other equipment from the box in which they were shipped.
2) Compare the serial number of the equipment with the number on the packing slip located on the
outside of the box and make sure they match.
3) Inspect the equipment carefully. If any of the equipment is damaged or missing, contact Technical
Support for assistance.
4) Verify that all circuit breakers on the product are set to ON. If not, turn them ON.
Or make sure that all fuses are inserted and seated properly. If there are any fuse covers,
ensure that they are closed.
Note: Not all models have overcurrent protectors.

Preparing the Installation Site

1) Make sure the installation area is clean and free of extreme temperatures and humidity.
Note: Check the product specification sheet for the maximum operating temperature for your model.
2) Allow sufficient space around the product for cabling and outlet connections.
3) Review Safety Instructions listed in this guide.
14
https://pdu.local to access the PRO3X instead of typing the link‑local IP
169.254.x.x/16 , which