LEGRAND Server Technology PRO3X User Manual page 160

Field Description
First/Second/ Manually specify static DNS server(s).
Third DNS server
You can manually configure or the route information using IPv4 and IPv6 static routes. See
Examples (on page 170) and
802.1x Security Overview
You can configure IEEE 802.1X authentication separately on each LAN port to give the PRO3X a secure
access on your LAN or WLAN. This authentication protocol will authenticate a user's identity based on
their credentials or certificate, which will be verified by their RADIUS authentication server. 802.1X uses
the uploaded certificate from the Certificate Repository to verify the user's identity. EAP_TLS or
EAP_PEAP are two authentication methods used in PRO3X to exchange the secure information. See
Setting Up a TLS Certificate
Ethernet (Wired) Interface Settings
On the Network page, click the ETHERNET section if the PRO3X has one port or click ETH1 and ETH2
sections respectively to configure each port. By default, both ETH1 and ETH2 interfaces are enabled.
▶
Bridging Cascading mode:
If the device's cascading mode is set to 'Bridging', the BRIDGE section appears. Then you must click the
BRIDGE section for IPv4/IPv6 settings.
160
• •
If any static DNS server is specified in these fields, it will
override the DHCP-assigned DNS server.
• •
If DHCP (or Automatic) is selected for IPv4/IPv6 settings, and
there are NO static DNS servers specified, DHCP-assigned DNS
servers are used.
Static Route Interface Names
(on page 195) to configure and upload the proper certificate.
(on page 172).
Static Route