Load Shedding Configuration Commands - LEGRAND Server Technology PRO3X User Manual

config:# serial consoleBaudRate 9600

Load Shedding Configuration Commands

This section applies to outlet-switching capable models only.
A load shedding configuration command begins with loadshedding.
Unlike other CLI configuration commands, the load shedding configuration command is performed in
the administrator mode rather than the configuration mode.
Enabling or Disabling Load Shedding
This section applies to outlet-switching capable models only.
This command determines whether to enter or exit from the load shedding mode.
# loadshedding <option>
After performing the above command, PRO3X prompts you to confirm the operation. Press y to confirm
or n to abort the operation.
To skip the confirmation step, you can add the "/y" parameter to the end of the command so that the
operation is executed immediately.
# loadshedding <option> /y
Variables:
• • <option> is one of the options: enable or disable.
Option
start
stop
▶
Example
The following command has the PRO3X enter the load shedding mode.
config:#
Description
Enter the load shedding mode.
Quit the load shedding mode.
loadshedding start
463