Usb Wireless Lan Adapters; Supported Wireless Lan Configuration - LEGRAND Server Technology PRO3X User Manual

▶
To make a wired connection:
1) Connect a standard network patch cable to one or both Ethernet ports on the PDU.
• If the two Ethernet ports have different speeds, use the higher speed port for network connection. •
2) Connect the other end of the cable to your LAN.
Warning: Accidentally plugging an RS-232 RJ-45 connector into the Ethernet port can cause permanent
damage(s) to the Ethernet hardware.
▶
To make a wireless connection:
Do one of the following:
• • Plug a supported USB wireless LAN adapter into the USB‑A port on your PDU.
• • Connect a USB hub to the USB-A port on the PDU. Then plug the supported USB wireless LAN
adapter into the appropriate USB port on the hub.

USB Wireless LAN Adapters

Supported USB Wi-Fi LAN adapters.
Wi-Fi LAN adapters
SparkLAN WUBR-508N
Proxim Orinoco 8494
Zyxel NWD271N
Edimax EW-7722UnD
TP-Link TL-WDN3200 v1
Raritan USB WIFI

Supported Wireless LAN Configuration

If wireless networking is preferred, ensure that the wireless LAN configuration of your PRO3X matches
the access point. The following is the wireless LAN configuration that the PRO3X supports.
• •
Network type: 802.11 a/b/g/n
• •
Protocol: WPA2 (RSN)
• • Key management: WPA-PSK, or WPA-EAP with PEAP and MSCHAPv2 authentication
• •
Encryption: CCMP (AES)
Tips: Supported 802.11 network protocols vary according to the wireless LAN
adapter being used.
22
Supported 802.11 protocols
a/b/g/n
a/b/g
b/g
a/b/g/n
a/b/g/n
a/b/g/n