Deleting An Outlet Group; Ocps - LEGRAND Server Technology PRO3X User Manual

2) Click the desired sensor (required), and then click Edit Thresholds.
3) Make changes as needed.
• To enable any threshold, select the corresponding checkbox. •
• • Type a new value in the accompanying text box.
4) Click Save.

Deleting an Outlet Group

To delete an outlet group, you must have either permission below.
• •
Administrator Privileges
• •
Change Pdu, Inlet, Outlet & Overcurrent Protector Configuration
You can delete one or multiple outlet groups at a time.
To delete a single outlet group only, there are two methods -- either Outlet Groups page or individual
group page.
▶
To delete one or multiple groups on the Outlet Groups page:
1) On the Outlet Groups page, select one or more outlet groups.
2) Click > Delete, then confirm the operation when prompted.
▶
To delete a group on a specific outlet group's page:
1) Open a specific outlet group's page by clicking on its name.
2) Click > Delete, then confirm the operation when prompted.

OCPs

The OCPs page is available only when your model has overcurrent protectors, such as circuit breakers.
The OCPs page lists all overcurrent protectors as well as their status. If any OCP trips or its current level
enters the alarmed state, it is highlighted in red or yellow.
To open the OCPs page, click 'OCPs' in the Menu.
You can go to each OCP's data/setup page by clicking its name on this page. OCPs may be numbered C1,
C2, and so on, or BR1, BR2 and so on.
126