Peripheral Devices Configuration Commands - LEGRAND Server Technology PRO3X User Manual

Example - Server Settings Changed
The following command modifies several ping monitoring settings for the second server in the server
reachability list.
config:# serverReachability modify 2 numberOfSuccessfulPingsToEnable 10
numberOfUnsuccessfulPingsForFailure 8
waitTimeAfterSuccessfulPing 30

Peripheral Devices Configuration Commands

You can use the CLI to set the Z Coordinate format for external sensors, set the device altitude, enable/
disable device auto management, set the active powered dry contact limit, and enable/disable the
"mute other door handle" setting.
Peripheral device configuration commands begin with:
config:# peripheralDevicesSetup
Field
externalSensorsZCoordinateFormat Keyword
rackUnits / freeForm
deviceAltitude
number1
peripheralDeviceAutoManagement Keyword
460
Description More Information
Z coordinate refers to the height of sensors.
rackUnits: The height of the Z coordinate is measured
Enter one of these
in standard rack units. Type a numeric value in the
values
rack unit to describe the Z coordinate.
freeForm: Any alphanumeric string can be used for
specifying the Z coordinate.
Keyword Specifies the altitude of your PDU above sea
level (in meters). Must be set if a differential air
pressure sensor is attached because the device's
altitude is associated with the altitude
correction factor.
Enter an integer Negative numbers indicate altitude below sea
number from -425 up level.
to 3000 when using
Meters.
Enable or disable the automatic management
feature for sensors.