Using The Hardware Features; Inlet; Zero U Models Relocatable Inlet - LEGRAND Server Technology PRO3X User Manual

Using the Hardware Features

Xerus firmware runs on various hardware designs, including different sizes and controllers.
In This Chapter
Inlet. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63
Outlets and Outlet LEDs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
Connection Ports. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
Front Panel Display. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65
Reset Button. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 72
Circuit Breakers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73
Replaceable Controller - PRO3X. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73
Threaded Grounding Point. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76

Inlet

Most of PRO3X PDUs are shipped with a locking line cord, which is ready to be plugged into the PDU's
inlet and an appropriate receptacle for electricity reception. Such devices cannot be rewired by the user.
A locking line cord helps secure the cord connection.
Connect each PRO3X to an appropriately rated branch circuit. Refer to the label or nameplate affixed to
your PRO3X for appropriate input ratings or range of ratings.
There is no power switch on the PRO3X. To power cycle the unit, unplug it from the branch circuit, wait
10 seconds and then plug it back in.
Some models support a relocatable inlet.

Zero U Models Relocatable Inlet

On supported Zero U models, change the inlet's location, either from the side or the top.
▶
To relocate the inlet position:
1) Power OFF the unit.
2) Remove the screws at two sides of the inlet to remove the inlet module.
3) Re-install the inlet module at the desired position, replacing the same screws.
63