LEGRAND Server Technology PRO3X User Manual page 437

config:# authentication ldap delete <server_num>
Variables:
• •
<server_num> is the sequential number of the specified server in the LDAP server list.
Radius Settings
All Radius-related commands begin with authentication radius.
If you enable Radius authentication, you must add at least one Radius server. Later you can modify or
delete any existing Radius server as needed.
Adding a Radius Server
You can repeat the following commands to add Radius servers one by one.
▶
Command syntax:
config:# authentication radius add <host> <rds_type> <auth_port>
<acct_port> <timeout> <retries>
Variables:
• •
<host> is the IP address or host name of the Radius server.
• •
<rds_type> is one of the Radius authentication types: pap, chap, msChapV2.
Type
chap
pap
msChapV2
• •
<auth_port> is the authentication port number.
• •
<acct_port> is the accounting port number.
• •
<timeout> is the timeout value in seconds. It ranges between 1 to 10 seconds.
• • <retries> is the number of retries. It ranges between 0 to 5.
▶
To enter the shared secret:
1) After executing the above Radius command, the system automatically prompts you to enter the
shared secret.
2) Type the secret and press Enter.
3) Re-type the same secret and press Enter.
Description
CHAP
PAP
MSCHAP v2
437