LEGRAND Server Technology PRO3X User Manual page 165

Field/setting Description
Allow connection If powered off for a long time, the system time may be incorrect.
if system clock is
When this checkbox is deselected, and if the system time is
incorrect
incorrect, the installed TLS certificate is considered not valid yet
and will cause the network connection to fail.
When this checkbox is selected, it will make the network
connection successful when the system time is earlier than
the firmware build before synchronizing with any NTP
server.
Wireless Network Settings
Wireless network is not supported for Bridging mode or for Expansion units in port forwarding mode.
Wireless interface is disabled by default. Enable it to use wireless networking.
On the Network page, click the WIRELESS section to configure wireless and IPv4/IPv6 settings.
▶
Interface Settings:
Field/setting Description
Enable interface Enable or disable the wireless interface.
When disabled, the wireless networking fails.
Hardware state Check this field to ensure that a wireless USB LAN adapter is
detected. If not, verify that the USB LAN adapter is firmly
connected or that it is supported.
SSID Type the name of the wireless access point (AP).
Force AP BSSID If the BSSID is available, select this checkbox.
BSSID Type the MAC address of an access point.
MTU Set the Maximum Transmission Unit from 1280 to 1500.
Enable High Enable or disable 802.11n protocol.
Throughput
(802.11n)
165