Unblocking A User; Reset Unit - LEGRAND Server Technology PRO3X User Manual

If you entered the command without "/y", a message appears, prompting you to confirm the operation. Then:
▪
Type y to confirm the operation, OR
▪
Type n to abort the operation
Example - Turning on a Specific Actuator
The following command turns on the actuator whose ID number is 8.
# control actuator 8 on

Unblocking a User

If any user is blocked from accessing the PRO3X, you can unblock them at the local console.
To unblock a user:
1. Access the CLI interface using any terminal program via a local connection.
2. When the Username prompt appears, type unblock and press Enter.
3. When the "Username to unblock" prompt appears, type the name of the blocked user and press Enter.
4. A message appears, indicating that the specified user was unblocked successfully.
Resetting the PRO3X
You can reset the PRO3X to factory defaults or simply restart it using the CLI commands.
Restarting the PDU
This command restarts the PRO3X. It is not a factory default reset.
To restart the PRO3X:
1. Ensure you have entered administrator mode and the # prompt is displayed.
2. Type either of the following commands to restart the PRO3X.
#

reset unit

-- OR --
# reset unit /y
3. If you entered the command without "/y" in Step 2, a message appears prompting you to confirm the operation.
Type y to confirm the reset.
4. Wait until the reset is complete.
PRO3X User Guide – Command Line Interface (CLI)
166 of 182
Using the PRO3X Command Line Interface (CLI)