Load Shedding Configuration Commands - LEGRAND Server Technology PRO4X User Manual

Option
automatic
forceConsole
forceAnalogModem The PRO4X attempts to recognize that the connected device
forceGsmModem
Example - Baud Rate
The following command sets the CONSOLE baud rate of the PRO4X device's serial port to 9600 bps.
config:# serial consoleBaudRate 9600

Load Shedding Configuration Commands

This section applies to outlet-switching capable models only.
A load shedding configuration command begins with loadshedding.
Unlike other CLI configuration commands, the load shedding configuration command is performed in
the administrator mode rather than the configuration mode.
Enabling or Disabling Load Shedding
This section applies to outlet-switching capable models only.
This command determines whether to enter or exit from the load shedding mode.
# loadshedding <option>
After performing the above command, PRO4X prompts you to confirm the operation. Press y to confirm
or n to abort the operation.
To skip the confirmation step, you can add the "/y" parameter to the end of the command so that the
operation is executed immediately.
522
Description
The PRO4X automatically detects the type of the device
connected to the serial port.
Select this option unless your PRO4X cannot correctly
detect the device type.
The PRO4X attempts to recognize that the connected device
is set for the console mode.
is an analog modem.
The PRO4X attempts to recognize that the connected device
is a GSM modem.