Replacing The Pump Tubes - Stratasys Objet30 User Manual

Objet30 User Guide

Replacing the Pump Tubes

Pump tubes in Objet30 printers are replaced during periodic preventive
maintenance (see "Preventive Maintenance Tasks" on page 6-108). The
procedure consists of these steps:
A. Preparation
B.
C.
D.
E.
Preparation
To replace the pump tubes:
1. Prepare the following tools and materials:
The three tubes supplied in the kit are identical; they can be used in the
pumps described in this section.
2. Close the printer application.
3. Shut down the printer computer, wait 60 seconds after the monitor goes
Caution:
The monitor goes blank as soon as the remote link terminates—before
computer shut down.
Turning off the printer before the computer shutdown can cause damage.
DOC-34025 Rev. I
Replacing the Waste Pump Tube
Replacing the Support Pump Tube
Replacing the Model Pump Tube
Returning Printer to Working Order
❒ key
❒ flat screwdriver
❒ protective gloves
❒ cleaning cloths
❒ wire cutter
❒ three replacement tubes and cable ties
blank, and turn off the main power switch.
6 Operating and Maintaining the Printer
6-92