REMOVAL OF REAR PANELS AND COVER
The rear service access panels and top cover can be removed in order to reduce the printer depth to an
absolute minimum of 34 inches (86.36 cm). If absolute minimum printer depth is not required, proceed to
"Service Connections" on page
To remove the rear service access panels:
1. Using a 5 mm Allen wrench, loosen but do not remove the 4 fasteners securing the upper rear panel
(see
Figure
10).
2. Set the panel aside.
3. Using a 5 mm Allen wrench, loosen but do not remove the 4 fasteners securing the lower rear panel
(see
Figure
10).
4. Set the panel aside.
Upper Panel
16.
Figure 10: Rear Panel Removal
Lower Panel
13