Show Ip Rip Database - Dell Z9500 Command Reference Manual

Version
6.2.1.1
Example
Dell(conf-router_rip)#show config
!
router rip
Dell(conf-router_rip)#

show ip rip database

Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
Z9500
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address
mask
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
1556
Description
Introduced on the E-Series.
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
(OPTIONAL) Specify an IP address in dotted decimal format
to view RIP information on that network only. If you enter an
IP address, also enter a mask for that IP address.
(OPTIONAL) Specify a mask, in /network format, for the IP
address.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Routing Information Protocol (RIP)