The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x mac-auth vlan-assign
Result
The VLAN ID for a MAC address is no longer assigned by the RADIUS server.
11.7.5.12
dot1x port-control
Description
With this command, you configure port control parameter of the authenicator.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x port-control {auto|force-authorized|force-unauthorized}
The parameters have the following meaning:
Parameter
auto
force-authorized
force-
unauthorized
The default value of the function is "
Result
The port control parameter is configured.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
Description
Authentication according to IEEE 802.1x is enabled for the interface.
The data traffic via the interface is permitted or blocked depending on the
authentication result.
data traffic via the interface is permitted without restrictions
Default:
force-authorized
data traffic via the interface is blocked
force-authorized
Security and authentication
11.7 Port Based Network Access Control
enabled
".
537