3.1.1.7
show interfaces
Description
This command shows the status and the configuration of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show interfaces
The parameters have the following meaning:
Parameters
interface-type
interface-id
description
stormcontrol
flowcontrol
status
vlan
vlan-id
port-channel
port-channel-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
If you do not select any parameters from the parameter list, the status and configuration of
all available interfaces will be displayed.
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
[{
[<interface-type><interface-id>]
[{description|stormcontrol|flowcontrol|status}]
|
{vlan<vlan-id(1-4094)>}
|
port-channel<port-channel-id(1-8)>
}]
Description
Type or speed of the interface
Slot no. and port no. of the interface
Shows the description of the interface
Shows the storm control settings
Shows the flow control settings
Shows the status of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a port channel connection
Number of the addressed port channel
Configuration
3.1 System
Range of values
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
-
-
-
-
-
1 ... 4094
-
1 ... 8
45