Adj 5.5 Dadh Registration Adjustment; Adj 5.6 Dadh Document Pad - Xerox WorkCentre 5790 Series Service Manual

ADJ 5.5 DADH Registration Adjustment

Parts List on PL 5.10
Purpose
To measure and adjust the image to paper registration.
Adjustment
Reset the DADH registration. Go to dC604
Repairs/Adjustments
ADJ 5.5, ADJ 5.6
Registration Setup Procedure.

ADJ 5.6 DADH Document Pad

Parts List on PL 5.10
Purpose
To correctly align the DADH document pad with the document glass.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
NOTE: If a new document pad is installed, make sure that the protective paper is removed
from the adhesive pads.
1. Raise the DADH. Put the document pad with the adhesive pads face-up on the document
glass.
2. Align the document pad with the document registration guides as shown in
Figure 1 Document pad alignment
3. Carefully lower then raise the DADH. Make sure the document pad is attached correctly.
May 2013
4-442
WARNING
14. Disconnect the power cord. Electricity can cause
Document registration
guides
Document pad
Xerox® WorkCentre® 5790 Family
Figure 1.