Fuji Electric FRENIC-HVAC User Manual page 450

P10 Motor 1 (Slip compensation response time)
P10 determines the response time for slip compensation. Basically, there is no need to modify
the default setting. If you need to modify it, consult your Fuji Electric representatives.
 For details about slip compensation control, refer to the description of F42.
P12 Motor 1 (Rated slip frequency)
P12 specifies rated slip frequency. Obtain the appropriate values from the test report of the
motor or by calling the manufacturer of the motor.
• Rated slip frequency:
(Note: The motor rating given on the nameplate sometimes shows a larger value.)
Rated slip frequency (Hz) =
 For details about slip compensation control, refer to the description of F42.
P99 Motor 1 Selection
P99 specifies the type of motor 1 to be used.
Data for P99
0
1
4
To select the motor drive control or to run the inverter with the integrated automatic control
functions such as auto torque boost and torque calculation monitoring, it is necessary to
specify the motor parameters correctly.
First select the Fuji standard motors 8-series with P99, next specify the motor rated capacity
with P02, and then initialize the motor parameters with H03. This process automatically
configures the related motor parameters (P01, P03, P06 through P08, P10, P12, and H46).
The data of F09 (Torque boost 1), H13 (Restart Mode after Momentary Power Failure
(Restart time)), and F11 (Electronic thermal overload protection for motor 1 (Overload
detection level)) depends on the motor capacity, but the process stated above does not change
them. Specify and adjust the data during a test run if needed.
Convert the value obtained from the motor manufacturer to Hz
using the following expression and enter the converted value.
(Synchronous speed - Rated speed)
Synchronous speed
Motor characteristics 0 (Fuji standard motors, 8-series)
Motor characteristics 1 (HP rating motors)
Other motors
6-140
× Base frequency
Motor type