Mounting And Connecting A Keypad; Parts Required For Connection; Mounting Procedure - Fuji Electric FRENIC-HVAC User Manual

5.2 Mounting and Connecting a Keypad

5.2.1

Parts required for connection

To mount/install a keypad on a place other than in an inverter, the parts listed below are needed.
Parts name
Extension cable
(Note 1)
Fixing screw
(Note 1) When using an off-the-shelf LAN cable, use a 10BASE-T/100BASE-TX straight type cable compliant with
US ANSI/TIA/EIA-568A Category 5. (Less than 20m (66 ft))
Recommended LAN cable
Manufacturer: Sanwa Supply Inc.
Model:
(Note 2) Use the screws with a length suitable for the wall thickness.
5.2.2

Mounting procedure

After completion of wiring, remove the keypad from the inverter and mount it to the panel using the
following procedure. Make sure that the inverter power is shut down beforehand.
(1) Remove the front cover, then remove the keypad by pulling it toward you with the hook held
down as directed by the arrows shown below.
For the front cover removal procedure, refer to Section 5.1.2.1 "Removing and mounting the

front cover and the wiring plate."
Model
CB-5S, CB-3S and CB-1S
M3 ×
 (Note 2)
KB-10T5-01K (1 m (3.3 ft))
KB-STP-01K: (1 m (3.3 ft)) (Shielded LAN cable to make the inverter compliant with the
EMC Directive)
Hook
Figure 5.7 Removing the Keypad
5-21

5.2 Mounting and Connecting a Keypad

Remarks
3 types available in length of 5m (16 ft), 3 m (9.8 ft),
and 1 m (3.3 ft).
Two screws needed. Purchase off-the-shelf ones
separately.