Setting Up Function Codes - Fuji Electric FRENIC-HVAC User Manual

 Function codes needed for double-key operation
Double-key operation is required to change the function codes F00 (Data Protection), H03 (Initialize
Data), H45 (Mock Alarm), H97 (Clear Alarm Data) and U107 (Automate Conversion Factor). Press
the key and the
 Revising, reflecting and storing function code data while running
Data for some function codes can be changed when the inverter is running; others cannot.
Furthermore, for some function codes, changing the data will cause those values to be reflected
immediately in inverter operation; for other function codes, they will not be reflected. For details,
refer to the column on changes while running in the "6.1 Function Code Table" in Chapter 6.
For details on function codes, refer to the "6.1 Function Code Table" in Chapter 6.

5.6.3.1

Setting up function codes

PRG > 2(Function Code) > 1(Data Set)
This section explains how to set function code data.
The examples below show how to change the high-output frequency function code F03 from 50 Hz
to 60 Hz.
Fref
0.00
Hz
STOP
Iout 0.00A
PWR 0.03kW
↓
PRG
0.Quick Setup
1.Start-up
2.Function Code
3.INV Info
4.Alarm Info
5.User Config
↓
/
PRG>2
1.Data Set
2.Data Check
3.Changed Data
4.Data Copy
5.Timer Setup
6.Initialize
↓
/
PRG>2>1
F:Fundamental
E:Extension
C:Control
P:Motor Param
H:High Perform
H1:High Perform
↓
/
key or the key and the
1. Press the
2. Use the
3. Use the
4. Use the
<Selection items>
←
Selected with
F,E,C,P,H,H1,J,J1,J2,
J3,J4,J5,J6,d,U,y,T,K,
o codes
5-47
5.6 Programming Mode
key.
Return to previous screen
key while the running mode
screen is displayed.
/ keys to select [2. Function
Code], and confirm with the
/ keys to select [1. Data Set],
and confirm with the key.
/ keys to select the function
code you wish to set (in this case, F:
Fundamental).
Return to running
key.