Fuji Electric FRENIC-HVAC User Manual page 256

↓
PRG>2>4>3
KP1→22AR1-4
Copying
20％
↓
PRG>2>4>3
KP1→22AR1-4
Done
Errors displayed during writing
PRG>2>4>3
KP1→22AR1-4
Com Error
0％
PRG>2>4>3
KP1→22AR1-4
Com Error
0％
PRG>2>4>3
KP1→22AR1-4
Com Error
0％
If a cancel operation screen, error screen or version mismatch screen is displayed, press the
or key to release. After resetting, the screen returns to programming mode.
7. While writing, the message "Copying..." is
displayed, and the percentage of progress is
shown.
8. If "Done." is displayed, the write operation
has concluded successfully.
Pressing the or
cancels the operation that is in progress, "Com
Error" is displayed on the cancel operation screen
, and the writing operation is forcibly
(Note)
terminated.
For safety reasons, the following conditions result
in errors.
• There is no data stored in the keypad memory.
(If no data has been read at any time since
shipping or if the operation was cancelled while
data was being read)
• There is an abnormality in the data stored in the
keypad memory.
• There is an abnormality in the inverter type.
• Data was written while the inverter was
running.
• Inverter data is protected.
• The WE-KP command ("Enable data change
with keypad") is OFF.
• There is an abnormality in the data stored in the
keypad memory.
• Terminal [FWD]/[REV] is ON.
The function codes stored in the keypad are not
compatible with the inverter function codes.
(Version upgrades may be non-standard or
incompatible. Please contact us.)
5-56
key during data writing