Fuji Electric FRENIC-HVAC User Manual page 325

Code Name
H184 Light Alarm Selection 4
H197 User Password 1 (Mode selection) 0: Disclose all function codes but prohibit any change
J codes: Application Functions 1
Code Name
J21 Dew Condensation Prevention
J22 Commercial Power Switching Sequence
J1 codes: PID Control 1
Code Name
J101 PID Control 1 (Mode selection) 0: Disable
J102 (Command selection) 0: Keypad ( /
J103 (Feedback selection) 1: PID control 1 feedback value
J104 (Deviation selection) 0: (J102)-(J103)
Data setting range
0 to 255
Bit 0: rEF
Bit 1: PA1, PA2, PAA, PAb, PAC
Bit 2: UTL
Bit 3: PTC
Bit 4: rTE
Bit 5: CnT
Bit 6: -
Bit 7: Lob, dtL
1: Disclose function codes selected for quick setup only and allow
change
* This specifies the protection of user password 1.
Data setting range
(Duty) 1% to 50%
0: Keep inverter operation (Stop due to alarm)
1: Automatically switch to commercial-power operation
Data setting range
1: Enable (Process control, normal operation)
2: Enable (Process control, inverse operation)
key)
1: PID command 1 (Analog input: Terminals [12], [C1] and [V2])
3: UP/DOWN
4: Command via communications link (Use function code S13)
10: Addition (PID control 1 feedback value + PID control 2
feedback value)
11: Difference (PID control 1 feedback value - PID control 2
feedback value)
12: Average (PID control 1 feedback value, PID control 2
feedback value)
13: Maximum (PID control 1 feedback value, PID control 2
feedback value)
14: Minimum (PID control 1 feedback value, PID control 2
feedback value)
1: Selection of maximum (selection of maximum for PID control 1
and 2 deviation)
2: Selection of minimum (selection of minimum for PID control 1
and 2 deviation)
6-15
6.2 Function Code Tables
Change
Data Default Related
when
copying setting page
running
Y Y 128 6-178
Y Y 0 6-180
Change
Data Default Related
when
copying setting page
running
Y Y 1 6-181
N Y 0
Change
Data Default Related
when
copying setting page
running
N Y 0 6-182
N Y 0 6-184
N Y 1 6-189
N Y 0 6-190