Fuji Electric FRENIC-HVAC User Manual page 570

Analog inputs 1 and 2 (U02, U03, etc.)

The following signals are available as input signals.
Data
8000 Analog general-purpose output signal (same with signals selected with F31,
F35: output frequency 1, output current, output torque, electric power
|
consumption, direct-current intermediate circuit voltage, etc)
8085
Example: In the case of the maximum frequency with output frequency 1,
100.00 is input as 100%.
Example: In the case of output current, 100.00 is input when the current is 200%
of the inverter rated value.
Note: 10 (universal AO) cannot be selected.
2001 Output of step 1
2002 Output of step 2
2003 Output of step 3
2004 Output of step 4
2005 Output of step 5
2006 Output of step 6
2007 Output of step 7
2008 Output of step 8
2009 Output of step 9
2010 Output of step 10
2011 Output of step 11
2012 Output of step 12
2013 Output of step 13
2014 Output of step 14
9001 Analog 12 terminal input signal
9002 Analog 12 terminal input signal
9003 Analog 12 terminal input signal
9004 Analog 32 terminal input signal
Analog C2 terminal input signal C2
9005
9006 Temperature detection Pt channel 1
9007 Temperature detection Pt channel 2
Value setting (U04, U05, etc)

The upper and lower limits of calculation circuit are specified.
Data
-9990.00 Reference value
to Hysteresis width
0.00 Upper limit
to Lower limit
+9990.00 Upper threshold value
Lower threshold value
Maximum scale
Minimum scale
Selectable Signals
SO01
SO02
SO03
SO04
SO05
SO06
SO07
SO08
SO09
SO10
SO11
SO12
SO13
SO14
12
C1
V2
32
Function
Set value in accordance with the calculation
circuit selected in mode setting such as U01.
Set value
6-260
Description