Conformity To The Low Voltage Directive In The Eu - Fuji Electric FRENIC-HVAC User Manual

11.1.1

Conformity to the Low Voltage Directive in the EU

If installed according to the guidelines given below, inverters marked with CE are considered as
compliant with the Low Voltage Directive.
Compliance with European Standards
Adjustable speed electrical power drive systems (PDS).
Part 5-1: Safety requirements. Electrical, thermal and energy. IEC/EN 61800-5-1
1. The ground terminal
residual-current-operated protective device (RCD)/earth leakage circuit breaker (ELCB)* as the
sole method of electric shock protection. Be sure to use ground wires of recommended size listed
Table 11.1.
*With overcurrent protection.
2. To prevent the risk of hazardous accidents that could be caused by damage of the inverter, install
the specified fuses in the supply side (primary side) according to the following tables.
- Breaking capacity: Min. 10 kA
- Rated voltage: Min. 500 V
Nominal
Power
applied
supply Inverter type
motor
voltage
(HP)
FRN001AR1-2U
1
2 FRN002AR1-2U
FRN003AR1-2U
3
5 FRN005AR1-2U
FRN007AR1-2U
7.5
10 FRN010AR1-2U
15 FRN015AR1-2U
Three-
FRN020AR1-2U 100 (IEC/EN 60269-2)
20
phase
25 FRN025AR1-2U 125 (IEC/EN 60269-2)
230 V
FRN030AR1-2U
30
40 FRN040AR1-2U
FRN050AR1-2U
50
60 FRN060AR1-2U
FRN075AR1S-2U
75
100 FRN100AR1S-2U
FRN125AR1S-2U
125
Note: A box () replaces an alphabetic letter depending on the enclosure.
M (NEMA/UL TYPE 1) or L (NEMA/UL TYPE 12)
G should always be connected to the ground. Do not use only a
Power
Fuse rating
supply
(A)
voltage
6 (IEC/EN 60269-2)
10 (IEC/EN 60269-2)
16 (IEC/EN 60269-2)
25 (IEC/EN 60269-2)
35 (IEC/EN 60269-2)
50 (IEC/EN 60269-2)
80 (IEC/EN 60269-2)
250 (IEC60269-4)
350 (IEC60269-4)
Three-
450 (IEC60269-4)
phase
460 V
500 (IEC60269-4)
FRENIC-HVAC
11-3
11.1 欧州規格の適合について
Nominal
applied
Inverter type
motor
(HP)
1 FRN001AR1-4U
2 FRN002AR1-4U
3 FRN003AR1-4U
5 FRN005AR1-4U
7.5 FRN007AR1-4U
10 FRN010AR1-4U
15 FRN015AR1-4U
20 FRN020AR1-4U
25 FRN025AR1-4U
30 FRN030AR1-4U
40 FRN040AR1-4U
50 FRN050AR1-4U
60 FRN060AR1-4U
75 FRN075AR1-4U
100 FRN100AR1-4U
125 FRN125AR1-4U
150 FRN150AR1S-4U
200 FRN200AR1S-4U
250 FRN250AR1S-4U
300 FRN300AR1S-4U
350 FRN350AR1S-4U
450 FRN450AR1S-4U
500 FRN500AR1S-4U
600 FRN600AR1S-4U
800 FRN800AR1S-4U
900 FRN900AR1S-4U
1000 FRN1000AR1S-4U
Fuse rating
(A)
4 (IEC/EN 60269-2)
6 (IEC/EN 60269-2)
10 (IEC/EN 60269-2)
16 (IEC/EN 60269-2)
20 (IEC/EN 60269-2)
25 (IEC/EN 60269-2)
35 (IEC/EN 60269-2)
50 (IEC/EN 60269-2)
63 (IEC/EN 60269-2)
80 (IEC/EN 60269-2)
100 (IEC/EN 60269-2)
125 (IEC/EN 60269-2)
250 (IEC60269-4)
350 (IEC60269-4)
400 (IEC60269-4)
450 (IEC60269-4)
500 (IEC60269-4)
550 (IEC60269-4)
630 (IEC60269-4)
900 (IEC60269-4)
1250 (IEC60269-4)
2000 (IEC60269-4)
第
11
章
「
規
格
対
応
」
に
つ
い
て