Fuji Electric FRENIC-HVAC User Manual page 603

K32 Display Coefficient for Input Watt-hour Data
K32 specifies a display coefficient for displaying the input watt-hour data.
The data can be checked by accessing PRG > 3(INV Info) > 4(Maintenance) in Programming
mode.
Input watt-hour data = Display coefficient (K32 data) x Input watt-hour (kWh)
- Data setting range: OFF (Cancel or reset), 0.001 to 9999.00
Setting K32 data to OFF clears the input watt-hour and its data to "0." After
clearing, be sure to restore the K32 data to the previous value; otherwise, input
watt-hour data will not be accumulated.
 The display coefficient can be specified easily in Programming mode as follows.
PRG > 1(Start-up) > 4(Disp Setting) > 13(WattHour Coef)
For detailed setting procedure, refer to Chapter 5, Section 5.6.2.4 "Specifying the
running status item to be monitored."
K33 Long-term, Input Watt-hour Data Monitor
K33 selects the cumulative period for input watt-hour data calculated by the inverter from
Hourly, Daily, Weekly and Monthly.
The inverter can save up to 48 sets of the cumulative data. If Monthly is selected, for example,
it is possible to check a maximum of 48-month (4-year) input watt-hour data.
The data can be checked by accessing PRG > 3(INV Info) > 4(Maintenance) in Programming
mode.
- Data setting range: OFF, 0 to 4
Data for K32
OFF
1
2
3
4
Cumulative period
Cancel and reset
Hourly
Daily
Weekly
Monthly
6-293
6.3 Details of Function Codes