Fuji Electric FRENIC-HVAC User Manual page 469

H45 Mock Alarm
H45 causes the inverter to generate a mock alarm in order to check whether external
sequences function correctly at the time of machine setup.
Setting the H45 data to "1" displays mock alarm Err on the LCD monitor. It also issues alarm
output (for any alarm) ALM (if assigned to a digital output terminal by any of E20 to E24 and
E27). (Accessing the H45 data requires simultaneous keying of "
that, the H45 data automatically reverts to "0," allowing you to reset the alarm.
Just as data (alarm history and relevant information) of those alarms that could occur in
running the inverter, the inverter saves mock alarm data, enabling you to confirm the mock
alarm status.
To clear the mock alarm data, use H97. (Accessing the H97 data requires simultaneous
keying of "
data.
A mock alarm can be issued also by simultaneous keying of
keypad for 5 seconds or more."
H46 Starting Mode (Auto search delay time 2)
For details, refer to the description of H09.
H47, H48 Initial Capacitance of DC Link Bus Capacitor
Cumulative Run Time of Capacitors on Printed Circuit Boards
For details, refer to the description of H42.
H49 Starting Mode (Auto search delay time 1)
For details, refer to the description of H09.
H50, H51 Non-linear V/f Pattern 1 (Frequency and Voltage)
H52, H53 Non-linear V/f Pattern 2 (Frequency and Voltage)
For details, refer to the description of F04.
H56 Deceleration Time for Forced Stop
For details, refer to the description of F07.
key + key.") H97 data automatically returns to "0" after clearing the alarm
6-159
6.3 Details of Function Codes
H97 (Clear Alarm Data)
key + key.") After
key + key on the
(
Refer to H09.)
(
Refer to H42.)
(
Refer to H09.)
(Refer to F04.)
(Refer to F07.)