Fuji Electric FRENIC-HVAC User Manual page 205

(3) Punching out semi-perforated sections in the wiring plate and setting conduits
Lightly tap the semi-perforated sections from the inside of the wiring plate using the hand grip of

a screwdriver or the like to punch them out.
Set the conduits on the wiring plate and then carry out wiring.

Take care not to get injured by the edge of the parts.
Figure 5.3 Punching Out Semi-perforated Sections in the Wiring Plate and Setting Conduits
If it is difficult to punch semi-perforated sections out of the wiring plate
Apply a rod with a sharp tip (e.g., chisel) to point "A" shown below and tap it using a hammer.
Connections
"A"
Block or the like
Take care not to deform the wiring plate.
5-5
5.1 Mounting and Wiring the Inverter
Hammer or the like
Chisel or the like
Wiring plate