Fuji Electric FRENIC-HVAC User Manual page 601

K20 Bar Chart 1 (Display item selection)
K21 Bar Chart 2 (Display item selection)
K22 Bar Chart 3 (Display item selection)
These function codes specify the items to be displayed in bar graphs 1 to 3 on the LCD
monitor.
- Data setting range: 1 to 26
Data for
Monitor item
K20 to K22
1 Output frequency 1
(before slip
compensation)
13 Output current
14 Output voltage
18 Calculated torque
19 Input power
25 Load factor
26 Motor output
 The monitor items for bar charts 1 to 3 can be selected easily in Programming mode as
follows.
PRG > 1(Start-up) > 4(Disp Setting) > 7(Bar Gage 1)
PRG > 1(Start-up) > 4(Disp Setting) > 8(Bar Gage 2)
PRG > 1(Start-up) > 4(Disp Setting) > 9(Bar Gage 3)
For detailed setting procedure, refer to Chapter 5, Section 5.6.2.4 "Specifying the
running status item to be monitored."
LCD
Monitor name
indicator
Output frequency
Output f1
(synchronous)
Output current Output I
Output voltage Output V
Calculated torque Torque
Consump-
Input power
tion W
Load
Load factor
factor
Motor output M output
6-291
6.3 Details of Function Codes
Unit Meaning of displayed value
Hz Reference frequency (Hz)
Current output from the inverter
A
in RMS
Voltage output from the inverter
V
in RMS
Motor output torque in %
%
(Calculated value)
kW Input power to the inverter
Load factor of the motor in % as
%
the rated output being at 100%
kW Motor output in kW