Fuji Electric FRENIC-HVAC User Manual page 599

(Note 6) These items appear when J501 or J504 (External PID control 1) ≠ 0.
(Note 7) These items appear when J601 (External PID control 2) ≠ 0.
(Note 8) This item appears when J601 (External PID control 1) ≠ 0 and %/EPID2 ("Cancel external PID
control 2") is assigned to any digital input terminal.
(Note 9) These items appear when J651 (External PID control 3) ≠ 0.
(Note 10) This item appears when J651 (External PID control 3) ≠ 0 and %/EPID3 ("Cancel external PID
control 3") is assigned to any digital input terminal.
 The monitor items can be selected easily in Programming mode as follows.
PRG > 1(Start-up) > 4(Disp Setting) > 2(Main Monitor)
For detailed setting procedure, refer to Chapter 5, Section 5.6.2.4 "Specifying the
running status item to be monitored."
K11 Main Monitor (Speed monitor item)
For details about the speed monitor items, refer to the description of K10.
 The monitor items can be selected easily in Programming mode as follows.
PRG > 1(Start-up) > 4(Disp Setting) > 3(Speed Monitor)
For detailed setting procedure, refer to Chapter 5, Section 5.6.2.4 "Specifying the
running status item to be monitored."
K12 Main Monitor (Display when stopped)
K12 specifies whether the specified value (data = 0) or the output value (data = 1) to be
displayed on the main monitor when the inverter is stopped. The monitored item depends on
the K11 (Main monitor, Speed monitor item) setting as shown below.
Data for K11
1 Output frequency 1
(before slip
compensation)
2 Output frequency 2
(after slip
compensation)
3 Reference frequency Reference frequency
4 Motor speed
5 Load shaft speed
8 Display speed (%)
 The monitor items can be selected easily in Programming mode as follows.
PRG > 1(Start-up) > 4(Disp Setting) > 3(Speed Monitor)
For detailed setting procedure, refer to Chapter 5, Section 5.6.2.4 "Specifying the
running status item to be monitored."
What to be displayed when the inverter stopped
Monitored item
K12 = 0: Specified value
Reference frequency
Reference frequency
Reference motor speed
Reference load shaft speed
Reference display speed
6-289
6.3 Details of Function Codes
(Refer to K10.)
K12 = 1: Output value
Output frequency 1
(before slip compensation)
Output frequency 2
(after slip compensation)
Reference frequency
Motor speed
Load shaft speed
Display speed