Extended Function Setting - Fuji Electric POD UG221H-LE4 User Manual

6-16
2. Main Menu Screen
6.

Extended Function Setting

When the [Editor: MJ1] switch on the Main Menu screen is pressed, the following "Extended Function
Setting" screen appears.
Set the baud rate to be used when transferring screen data between the Simple POD and a modem.
1. Select the desired baud rate using the [↑] / [↓] switch, and press the [Setting Finished] switch.
(Setting range: 4800, 9600, 19200, 38400, 57600, 115200)
* The function switches and switches on the Main Menu screen are not valid for 15 seconds
after the [Setting Finished] switch is pressed.
* When the [Setting Finished] switch is pressed, an AT command is automatically sent to the
modem and the baud rate used between the Simple POD and the modem is set.
2. The [Main Menu] (local main) screen is displayed automatically. [Modem Connect Mode]
automatically appears at the right side of [Editor: MJ1].
3. To transfer screen data without a modem, select "Not used" for [Modem Comm. Baud Rate].
For screen data transfer while a computer is connected with UG00C-T, specify [Not Used] for
[Modem Comm. Baud Rate].
POWER
Pressing the [Editor: MJ1] switch
brings up the "Extended
Function Setting" screen.
Pressing the [Setting Finished] switch
moves back to the Main Menu screen.
POWER
POWER
SYSTEM
F1
F2
F3
F4
F5