Analog Signal Range Setting Function; Parameter Setting Function; Supported Versions; Supported Version Of Program Loader - Fuji Electric NA0AX06-MR User Manual

Section 1 Overview

1-2-2 Analog signal range setting function

You can set the analog input and analog output signal range by using the jumper pin of the analog unit. Therefore, a program for
the range setting is not required.

1-2-3 Parameter setting function

You can set the parameters of the analog unit by using a program loader. The parameter setting items are as follows:
• Analog input unit (Type: NA0AX06-MR): Moving average, resolution
• Analog input/output unit (Type: NA0AW06-MR): Moving average, resolution (for analog input only)
• Analog input/output board (Type: NA3AW03-MR): Moving average, resolution (for analog input only)
• Thermocouple input unit (Type: NA0AX02-TC/NA0AX06-TC/NA0AX16-TC)
: Thermocouple type, moving average, sampling period (resolution), unit (Celsius or Fahrenheit)
• Resistance thermometer element input unit (NA0AX06-PT)
: Resistance thermometer element type, moving average, sampling period, unit (Celsius or Fahrenheit)

1-3 Supported Versions

1-3-1 Supported version of program loader

• SX-Programmer Expert (D300win) : V3.6.11 or later
• SX-Programmer Standard

1-3-2 Supported version of main unit

• V03 or later software version of the main units support analog boards that are connected on the front of them (Type:
NA3AY02-MR, NA3AW03-MR). Analog boards cannot be used with a main unit the software version of which is earlier than
V03.
: V3.0.16 or later
1-2