Pa2_77 Initial Display Of The Keypad (Keypad); Pa2_78 Display Transition At Warning Detection - Fuji Electric Alpha7 VV User Manual

PA2_77 Initial display of the keypad (Keypad)

No. Name
0: Sequence mode. 1: Feedback speed. 2: Command speed.
3: Command torque. 4: Motor current. 5: Peak torque.
6: Effective torque. 7: Feedback position.
8: Command position. 9: Position deviation.
10: Command pulse frequency. 11: Feedback cumulative pulse.
12: Command cumulative pulse. 13: LS-Z pulse.
Initial
14: Load inertia ratio. 15: DC link voltage (max.).
display of
16: DC link voltage (min.). 17: VREF input voltage.
the keypad
18: TREF input voltage. 19: Input signals. 20: Output signals.
77
(Data
21: OL thermal value. 22: Regenerative resistor thermal value.
displayed on
23: Power (W). 24: Motor temperature. 25: Overshoot unit amount.
keypad)
26: Settling time. 27: Resonance frequency 1.
28: Resonance frequency 2. 40: Station number.
41: Alarm at present. 42: Alarm history . 43: Warning at present.
44: Total time - main power supply.
45: Total time - control power supply.
46: Motor running time.
Specify the data displayed on the keypad at the upper part of the front of the amplifier when the power
is turned on.

PA2_78 Display transition at warning detection

No. Name
Display transition at
78
warning detection
Select whether or not a warning sign is displayed at the keypad on the front panel of the amplifier when
a "cooling fan life expiration," "main circuit capacitor life expiration," or "low battery voltage" warning is
detected.
If the replacement timing is drawing near after several years of operation, change this parameter to "1"
to show a warning on the keypad in front of the servo amplifier.
Setting range
Setting range
0: No transition 1: Transition to
warning display
Extended Function Setting Parameters
CHAPTER 4 PARAMETER
Default
Change
value
0 Power
Default
Change
value
0 Power
4
4-93