Table of Contents
Advertisement
■
Trimming Colors
Trimming colors can be set for each line by setting color codes in bits LF3 to LF0 of line control
data set 1 (command 3).
■ Trimming Display Rules
•
Trimming dots for a character can be displayed in the right-side or left-side adjacent character
area only when the character background types of the two characters are the same.
•
Trimming dots for the character at the left or right end of a line can be displayed beyond the
character area only when the character background type is "no character background."
•
Trimming dots on a line are also enlarged when the line is displayed enlarged (if bits LG1 and
LG0 of line control data set 2 [command 4] are set to other than 0, 0).
Note:
If OSDC display color output control (DCX) is set to 0, the set color code is used. If DCX is set to 1,
the color code with the bit inverted from 0 to 1 or vice versa becomes the palette read address.
CHAPTER 18 OSDC
497
Advertisement
Table of Contents
