Fujitsu MB91319 Series Hardware Manual page 528

CHAPTER 18 OSDC
■ Color to be Replaced by the Character Color (Setting for Each Screen)
Figure 18.2-35 shows an example color replacement of graphic color control (command 6-3): Bits
GC3 to GC0.
Figure 18.2-35 Example Replacement of the Code of the Color to be Replaced by the Character
Color (Setting for Each Screen)
GF3 to GF0:
Specified color
to be replaced
[Displayed according to color
information in the font RAM]
Notes:
• When graphic color/character color replace control is on (bit GCC is set to 1), transparent color
control is on (bit TCC of transparent color control [command 6-2] is set to 1), and the color to be
replaced by the graphic color/character color and transparent color (bits TC3 to TC0) of
transparent color control (command 6-2) are the same, priority is given to replacement by
character color.
• When graphic color/character color replace control is on (bit GCC is set to 1), transparent color
control is on (bit TCC of transparent color control [command 6-2] is set to 1), and the character
color (bits MC3 to MC0) of character data set 1 (command 1) and the transparent color (bits TC3
to TC0) of transparent color control (command 6-2) are the same, priority is given to the
transparent color and the lower-layer color is displayed.
• When graphic color/character color replace control is on (bit GCC is set to 1) and graphic color/
trimming color replace control is on (bit GFC is set to 1), set the difference colors for the color
replaced by the character color (bits GC3 to GC0) and the color replaced by the trimming color
(bits GF3 to GF0).
506
Trimming color:
(Specified by bits MC3
to MC0 in command 1)
GCC = 1
Replaced by
the character
color
GCC = 0
[Displayed in the specified
replacing color]