H3C s3600 series Command Manual page 1229

address-list: IP address list. You need to provide this argument in the format of start-ip-address
[ ip-address-number ] & < 1-10 >, where start-ip-address is the start IP address of an IP address range
in the address pool, ip-address-number specifies the number of the successive IP addresses following
start-ip-address in the range, and & < 1-10 > means you can specify up to ten IP addresses/IP address
ranges.
Description
Use the am ip-pool command to configure the access management IP address pool on a port. For a
port with the access management IP address pool configured, only the hosts with their IP addresses
being in the access management pool can access external networks through the port.
Use the undo am ip-pool command to remove part of or all the IP addresses from the access
management IP address pool of a port.
By default, the access management IP address pool is null.
Note that:
Before configuring the access management IP address pool of a port, you need to configure the
interface IP address of the VLAN to which the port belongs, and the IP addresses in the access
management IP address pool of a port must be in the same network segment as the interface IP
address of the VLAN which the port belongs to.
If an access management address pool configured contains IP addresses that belong to the static
ARP entries of other ports, the system prompts you to delete the corresponding static ARP entries
to ensure the access management IP address pool can take effect.
Examples
# Configure the access management IP address pool on Ethernet 1/0/1 to allow hosts with their IP
addresses being in the range 202.112.66.2 to 202.112.66.20 and 202.112.65.1 to access external
networks through the port.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] am ip-pool 202.112.66.2 19 202.112.65.1
# Remove all the IP addresses from the access management IP address pool of port Ethernet 1/0/1.
[Sysname-Ethernet1/0/1] undo am ip-pool all
am trap enable
Syntax
am trap enable
undo am trap enable
View
System view
Parameters
None
1-2