Ftp-Operation - H3C s3600 series Command Manual

The frequency command does not apply to DHCP tests.
The frequency command supports fabric only when the test type of this test group is ICMP. With
fabric enabled, you are allowed to configure the frequency command and use the display
command to check your configuration, but unless the test type is ICMP, your configuration does not
take effect until fabric is disabled.
Examples
# Set the automatic test interval to 10 seconds in an ICMP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator icmp
[Sysname-hwping-administrator-icmp] test-type icmp
[Sysname-hwping-administrator-icmp] destination-ip 169.254.10.3
[Sysname-hwping-administrator-icmp] frequency 10

ftp-operation

Syntax
ftp-operation { get | put }
View
HWPing test group view
Parameters
get: Specifies the test operation as download from the FTP server.
put: Specifies the test operation as upload to the FTP server.
Description
Use the ftp-operation command to configure the FTP operation mode, which can be get and put.
By default, the FTP operation mode is get.
Related commands: username, password.
The ftp-operation command applies to FTP tests only.
Examples
# Set the FTP operation mode to put in an FTP test.
<Sysname> system-view
1-13