Related commands
flow-interval
•
•
reset counters interface
display counters rate
Use display counters rate to display traffic rate statistics for interfaces in up state over the last statistics
polling interval.
Syntax
display counters rate { inbound | outbound } interface [ interface-type [ interface-number |
interface-number.subnumber ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
inbound: Displays inbound traffic rate statistics.
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
interface-number.subnumber: Specifies a subinterface number. The interface-number argument is an
interface number. The subnumber argument is the number of a subinterface created under the interface.
The value range for the subnumber argument is 1 to 4094.
Usage guidelines
If you do not specify an interface type, this command displays traffic rate statistics for all up interfaces
that have traffic counters over the last statistics polling interval.
If you specify an interface type, this command displays traffic rate statistics for all up interfaces of the
specified type over the last statistics polling interval.
If an interface that you specify is always down over the last statistics polling interval, the system prompts
that the interface does not support the command.
You can use the flow-interval command to set the statistics polling interval.
Examples
# Display the inbound traffic rate statistics for all GigabitEthernet interfaces.
<Sysname> display counters rate inbound interface gigabitethernet
Interface
GE1/0/1
GE1/0/2
GE1/0/3
Total (pps)
Broadcast (pps)
200
300
300
10
Multicast (pps)
100
200
200
100
100
100