device relates the VLAN interface to the IPv6 address to uniquely identify a static neighbor entry
which is in REACH state.
You only need to specify the corresponding VLAN interface when removing a static neighbor entry
related to that VLAN interface.
Related commands: display ipv6 neighbors.
Examples
# Configure a static neighbor entry for Ethernet 1/0/1 of VLAN 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 1 Ethernet 1/0/1
ipv6 neighbors max-learning-num
Syntax
ipv6 neighbors max-learning-num number
undo ipv6 neighbors max-learning-num
View
VLAN interface view
Parameters
number: Maximum number of neighbors that can be dynamically learned by an interface, in the range of
1 to 2048.
Description
Use the ipv6 neighbors max-learning-num command to configure the maximum number of neighbors
that can be dynamically learned on a specified interface.
Use the undo ipv6 neighbors max-learning-num command to restore the configuration to the default.
By default, the maximum number is 1024.
Examples
# Set the maximum number of neighbors that can be dynamically learned on the interface
VLAN-interface 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 1
[Sysname-Vlan-interface1] ipv6 neighbors max-learning-num 10
ipv6 route-static
Syntax
ipv6 route-static ipv6-address prefix-length [ interface-type interface-number] nexthop-address
undo ipv6 route-static ipv6-address prefix-length
1-27