Schedule Reboot Delay - H3C s3600 series Command Manual

The switch timer can be set to a precision of one minute, that is, the switch will reboot within one minute
after the specified reboot date and time.
Note that:
After you execute the schedule reboot at command with a specified future date, the switch will
reboot at the specified time with at most one minute delay.
After you execute the schedule reboot at command without specifying a date, the switch will
reboot at the specified time on the current day if the specified time is later than the current time, or
reboot at the specified time on the next day if the specified time is earlier than the current time.
After you execute the command, the system will prompt you to confirm. Enter "Y" or "y" for your
setting to take effect, and your setting will overwrite the previous one (if there is a setting already
exists).
If you adjust the system time by the clock command after executing the schedule reboot at
command, the configured schedule reboot at command will be invalid and the scheduled reboot
will not happen.
Related commands: reboot, display schedule reboot.
Examples
# Suppose the current time is 05:06, schedule a reboot so that the switch reboots at 22:00 on the
current day.
<Sysname> schedule reboot at 22:00
Reboot system at 22:00 2000/04/02(in 16 hours and 53 minutes)
confirm?[Y/N]:y
<Sysname>

schedule reboot delay

Syntax
schedule reboot delay { hh:mm | mm }
undo schedule reboot
View
User view
Parameters
hh:mm: Reboot waiting delay, where hh ranges from 0 to 720, and mm ranges from 0 to 59. The value of
hh:mm can be up to 720:00.
mm: Reboot waiting delay, ranging from 0 to 43,200 minutes.
Description
Use the schedule reboot delay command to enable the delay reboot function on the switch, and set
the reboot delay time.
3-18